20
FAULT-FINDING
www.geckodocs.com
DIAGNOSTICS - OPERATION
Once commissioned, your Riptide Spa should operate normally when properly set up. If, however, you
encounter operating problems please use this general guide. If this guide does not help you solve the
problem please contact your dealer.
TROUBLESHOOTING GUIDE
Spa can’t start in any mode.
automatically when using the
spa.
The water pumps are
operating but no water is
coming out of the jets.
Spa water is heating slowly
and / or not reaching
required temperature.
The power of the jets is low.
The jet water power
shows error message).
creating heat loss.
fully open.
the spa.
Check the power supply to the
spa. Check the error message
on pages 10-12 and contact
your dealer.
Press the pump button to
restart the pump. Stop running
pump for 1 hour until cool and
then restart the pump
Try to restart the jet. Introduce
clear any possible air block.
Re-set the temperature.
Put the cover on the spa.
Contact your dealer.
Check whether there are
foreign bodies inside the jets.
Check if water pump’s valve is
fully open.
Check whether there are
Add more water to the spa.
To Next Page
Loading...
