What to do if my Riso RZ1090 Printer displays 'Wrong-Type Print Drum (Cylinder) Installed'?
If your Riso printer displays 'Wrong-Type Print Drum (Cylinder) Installed', it means an incorrect Print Drum (Cylinder) is installed. Install a correct Print Drum (Cylinder) that is specifically designed and approved for use with this machine. Failure to do so may cause problems or damage to the machine.
Why does my Riso Printer say 'No Ink'?
If your Riso Printer is showing a 'No Ink' message, it means the ink cartridge is empty. Replace the old ink cartridge with a new one that is specifically designed for your machine. If the error continues after replacing the ink cartridge, double-check that the ink cartridge is installed correctly.
How to fix a paper jam in my Riso RZ1090?
If your Riso printer has a paper jam, follow these steps: 1) Remove the jammed paper. 2) Press the key or touch [OK].
What to do if my Riso Printer displays 'Master Disposal Box is Full'?
If your Riso printer shows 'Master Disposal Box is Full', it means the Master Disposal Box needs to be emptied. Empty the Master Disposal Box to continue printing.
Why is my Riso RZ1090 Printer showing 'No Master'?
If your Riso printer is displaying a 'No Master' message, it means the Master Roll is depleted. Install a new Master Roll that is specifically designed for use with your machine.
What to do if my Riso RZ1090 Printer displays 'Set Master Disposal Box in Place'?
If your Riso printer displays 'Set Master Disposal Box in Place', it means the Master Disposal Box is improperly set or is missing. Properly set the Master Disposal Box.
What to do if my Riso Printer displays 'No Paper Tape in Job Separator'?
If your Riso printer displays 'No Paper Tape in Job Separator', it means there is no tape in the Job Separator (option). Load new tape into the Job Separator.
What to do if my Riso RZ1090 displays 'Paper Tape Jam in Job Separator'?
If your Riso printer displays 'Paper Tape Jam in Job Separator', it indicates that a tape jam occurred in the Job Separator (option). Check the Job Separator and remove jammed tape.
What to do if my Riso RZ1090 Printer displays 'Wrong-type Ink Cartridge Installed'?
If your Riso printer displays 'Wrong-type Ink Cartridge Installed', it means an inappropriate Ink Cartridge is installed. Properly install a correct Ink Cartridge that is specifically designed and approved for use with your machine. Failure to do so may cause problems or damage to the machine.
What should I do if my Riso RZ1090 Printer says 'System Error'?
If your Riso printer displays 'System Error', turn the main power switch off, and then on again to restart it. If the recovery fails, contact your dealer or authorized service representative.
To Next Page
General