24
VI. MAINTENANCE
MAINTENANCE METHOD:
To extend the service life of the device, the parts must be lubricated on
time. The product has been initially lubricated before leaving the factory,
but lubrication is required between the guide rod and the weight plate over
time.
1. Pulley and wire ropes should be regularly checked for signs of wear.
2. Check and adjust the tension of the wire rope regularly.
3. Check all moving parts regularly. If there is a damaged part, stop using
the device immediately and contact the store.
4. Ensure all bolts and nuts are fully fixed and re-tighten them when it is
loose.
5. Check the welding for cracks.
6. Failure to perform routine maintenance may cause personal injury or
equipment damage.
7. Ensure any handle attachments are fully secured before use to prevent
from injury.
To Next Page
Loading...