Rittal BC 1007 HS - Page 3

3
3.4.2 Testing for Oil Delivery ...............................................................................................18
3.4.3 Air Pressure Adjustment ............................................................................................18
3.4.4 Adjustment of the Mist Volume.................................................................................19
3.4.5 Oil Conversion from MK 150 to MK 200 ....................................................................19
3.4.6 Adjusting the Oil Mist Angle ......................................................................................20
Vacuum System .................................................................................................................21
3.5.1 Nilfisk Vacuum Canister .............................................................................................21
3.5.2 Vacuum Hose .............................................................................................................21
3.5.3 Pressure Plate Manifold .............................................................................................21
3.5.4 Chip Trap/Dropout .....................................................................................................22
3.5.5 Vacuum Seal ...............................................................................................................22
3.5.6 Testing the Vacuum System – F-Test Manual Operation ..........................................23
Spindle ...............................................................................................................................23
3.6.1 Spindle Chuck .............................................................................................................23
3.6.2 Cooling Fan .................................................................................................................24
Tools ..................................................................................................................................24
Tool Breakage Sensor ........................................................................................................25
Clamping System ...............................................................................................................25
3.9.1 Panel Clamp Cleaning and Lubrication ......................................................................25
3.9.2 Enclosure Clamp Cleaning ..........................................................................................25
Electrical Enclosure ........................................................................................................26
3.10.1 Fan Intake and Exhaust Filters ...................................................................................26
3.10.2 Electrical Power – Incoming Voltage..........................................................................26
3.10.3 Air Pressure Cutout Switch ........................................................................................26
Resetting PM Notifications ............................................................................................27
3.11.1 Machine Parameters - Maintenance .........................................................................27