Rittal PDU metered/metered plus/switched/managed 23
EN
1 Notes on documentation
The PDU portfolio comprises a high-volume product available off-the-shelf, a high-volume product
built-to-order as well as PDUs configured-to-order. All PDUs from our standard range have the typical
7-digit Rittal Model No., while customised PDUs have a unique 7-digit KID number (beginning with a
letter, such as y) for easy identification and reordering.
The precise technical PDU description is stored in an alphanumerical "PDU ID", which should be quoted
when requesting servicing of customised PDUs.
This information can be found on the PDU rating plate. Additionally, this and other product information
(serial number etc.) can also be retrieved from the PDU website if necessary and via the display, by us-
ing different QR codes.
With the display switched on, the first QR code is displayed by pressing and holding down the "ESC"
key for 3 s (fig.
12, item 1) until the display timeout is reached or any other key is pressed. The "Up" key
(
fig. 12, item. 2) and the "Down" key (fig. 12, item. 5) allow switching between the different QR codes.
The following information is stored in the QR codes:
"PDUi Info": contains the information printed on the PDU rating plate.
"Network Info": contains all set network information.
"System Info": contains all system information.
"Phase 1 Info", "Phase 2 Info" and "Phase 3 Info": contain the measured values of the associated
phase. These values are recalculated and refreshed every 3 seconds (approx.).
"Controller Info": contains the information printed on the PDUi controller rating plate.
The following operating instructions refer to the PDU standard range, unless otherwise stated in the
text. Minor deviations may arise during assembly and commissioning when using a built-to-order PDU.
This Installation and Short User Guide is intended for experienced, trained specialists and contains only
the most important information concerning the assembly, installation and function of the PDU power
distribution unit (subsequently referred to as the PDU).
1.1 Other applicable documents
– Assembly, installation and operating instructions for the PDU metered/metered plus/switched/mana-
ged power distribution unit.
These are available at www.rittal.com and contain comprehensive application-relevant information and
technical data for the PDU with regard to:
– Details concerning the electrical connection
– Functions and services
– Configuration optionsPDU metered/metered plus/switched/managed
– Detailed operating instructions
– Troubleshooting
1.2 Storing the documents
These instructions as well as all applicable documents are an integral part of the product. They must
be issued to everyone who works with the unit and must always be available and on hand for operating
and maintenance personnel.
Notes on documentation
EN
To Next Page
Loading...
Need help?
General