Installation and Operation
UPS-Manual 11
EN
4. Installation and Operation
Warning!
Read the Safety Instruction guide
(page 5 to 6) before installing the
UPS!
4.1. Unpacking
Inspect the UPS upon receipt. The manufac-
turer designed robust packaging for your prod-
uct. However, accidents and damage may oc-
cur during shipment. Notify the forwarder and
dealer if there is damage.
The packaging is recyclable; save it for reuse
or dispose of it properly.
• Remove the UPS from the carton box.
• Check the package contents. Standard
content shall includes:
-
1 set of User's Manual
-
2 pcs of IEC output cables (for UPS with
IEC sockets only)
-
1 pc of AC Input Power Cord
-
1 set of UPS communication software with
RS232 and USB cable
-
1 set of Tower/Rack Accessories Kit
4.2. Selecting Installation Position
Warning!
The UPS is heavy.
Select a location sturdy enough to handle the
UPS weight. To ensure proper operation and
long operating life, always position the UPS
according to the following requirement:
1. Keep minimum 20cm (8 inches) distance
clearance from the rear panel of the UPS to
avoid any obstructions.
2. Do not block the air-flow to the ventilation
louvers of the unit.
3. Please ensure the installation site is free
from excessive dust and the ambient tem-
perature and humidity should be within the
specified limits.
4. Do not place the UPS in a dusty or corrosive
environment or near any flammable objects.
5. This UPS is not designed for outdoor use.
4.3. Set up
4.3.1. Tower Configuration Setup
30%~90%
Relative humidity
(non condensation)
To Next Page
Loading...
Need help?
General
