Why does my Rival Iron leave water spots on clothing?
If your Rival Iron leaves water spots on clothing, allow approximately 2 minutes for the steamer to preheat before use. Also, periodically lift the steam nozzle/handle as high as possible to let any condensation in the flexible steam hose drain back into the unit.
How to fix a Rival 11560 Iron that won’t steam?
If your Rival Iron unit won’t steam, ensure the water tank has water, the unit is plugged in, and switched to the ON (I) position. If water deposits have built up in the unit, refer to the “Care and Cleaning” section for guidance. Also, avoid holding the steam handle/nozzle too low for more than 20 seconds to prevent steam condensation inside the hose, which can block normal steam flow. Periodically lift the steam nozzle/handle as high as possible to allow any condensation in the flexible steam hose to drain back into the unit.
Why does the flexible steam hose on my Rival 11560 Iron make a gurgling noise?
The gurgling noise from the flexible steam hose of your Rival Iron during use is normal. To maintain steam flow, fully extend the flexible steam hose to allow steam to flow freely.
Additional safety guidelines for household use, including direct steam application and avoiding pets.
Instructions for connecting the flexible steam hose to the main unit base.
Details on using the creasing attachment for specific fabric areas.
Guidance on using the brush attachment for upholstery and lint removal.
To Next Page
General
