-4-
HOW TO USE YOUR ICE CREAM MAKER
NOTE: Before using for the first time, wash all parts except
MOTOR DRIVE (see “HOW TO CLEAN YOUR ICE CREAM MAKER”).
1. Pour chilled ice cream mixture into cooled ICE CREAM CAN. Fill ICE
CREAM CAN only
3
/4 full, as mixture will expand during freezing.
2. Insert DASHER. Be sure that bottom of DASHER fits indentation at
bottom of ICE CREAM CAN.
3. Place COVER on ICE CREAM CAN.
• Motor Drive
Top mounted. Engages stem of DASHER.
• Cork
Used to plug hole in COVER when
hardening and ripening ice cream.
• Cover
Tab in COVER fits notch in ice cream can.
• Dasher
Stem on top fits through hole in center of
COVER, and engages MOTOR DRIVE.
• Ice Cream Can
Container holds ice cream mixture.
• Drain Hole
Allows salt water to flow freely out of
BUCKET.
• Bucket
Latch and tab plates secure MOTOR DRIVE.
Drain hole located near top of BUCKET. Holds rock salt and ice.
motor drive
cork
cover
dasher
ice cream can
bucket
drain hole
latch
tab plates
KNOW YOUR ICE CREAM MAKER
To Next Page
Loading...
