Page 23 of 30 20160927-Ver.1
DANGER
Do not lean over appliance while lighting.
FLAME CHARACTERISTICS
This procedure outlines how to check for proper
burner flame characteristics.
Burner flames should be blue and stable with little
yellow tips, with no excessive noise, or lifting. If the
flame is yellow, it indicates insufficient air. If the
flame is noisy and tends to lift away from the
burner, it indicates too much air. If any of these
conditions exist, call our customer service line.
Visually check the burner flames prior to each use.
The flames should look like this picture. If not, refer
to the burner maintenance part of this manual.
CAUTION
If burner does not light OR if burner flame is accidentally extinguished, turn knob to OFF, wait 5
minutes, try again. If the burner does not ignite with valve open OR if burner flame goes out
after lighting, gas will continue to flow out of the burner and could accidentally ignite with risk of
injury.
To Next Page
Loading...
Need help?
General
