Page 25 of 30 20160927-Ver.1
Although an obstructed burner tube is not the only cause of flashback, it is the most common
cause. To reduce the chance of flashback, you must clean the burner tube before assembling
your appliance, and at least once a month in late summer or early fall when spiders are most
active. Also, perform this burner tube cleaning procedure if your appliance has not been used for
an extended period of time.
You should inspect the burner at least once a year or immediately after any of the following
conditions occur:
1. The smell of gas in conjunction with the burner flames appearing yellow.
2. The appliance does not reach temperature.
3. The appliance heats unevenly.
4. The burner makes popping noises.
WARNING
ENSURE that the gas supply and the knob are in the OFF position BEFORE cleaning the
burner.
DISASSEMBLE THE BURNER
1. Turn off the gas supply and make sure the knob is in the OFF position then disengage
regulator from cylinder.
2. Wait for the appliance to cool.
3. Open the lid and remove the basket, flame tamers and grease collector. This will expose the
burner from inside.
4. Remove the burner fixing bolts as shown at Step “A” below.
5. Disconnect electrode wire from the gas valve as shown at Step “B” below.
6. Remove the burner from the appliance.
Step A Step B
To Next Page
Loading...
Need help?
General
