Riverside Hydronics TempTrac - 1. DISPLAY AND INTERFACE; 1.1 KEYBOARD BUTTONS; 1.2 KEY COMBINATIONS; 1.3 LED ICON LEGEND

Page 2/ 24 34-81 10/2013
INDEX
1. TECHNICAL DATA _________________________________________________________________ 3
2. WIRING DIAGRAMS ________________________________________________________________ 3
3. DISPLAY AND INTERFACE __________________________________________________________ 4
3.1 KEYBOARD __________________________________________________________________ 4
3.2 LED ICON LEGEND ____________________________________________________________ 5
3.3 UPPER LED READOUT (RED) ___________________________________________________ 6
3.4 LOWER LED READOUT (YELLOW) _______________________________________________ 6
3.5 TO SET THE CURRENT TIME AND DAY (24 HOUR CLOCK) ___________________________ 6
3.6 TO SET THE ENERGY SAVINGS TIME ____________________________________________ 7
3.7 TO SET THE MODULATION OUTPUT MANUALLY ___________________________________ 7
3.8 HOW TO SEE THE WORKING HOURS OF RELAY OUTPUTS __________________________ 7
3.9 HOW TO RESET THE WORKING HOURS OF RELAY OUTPUTS _______________________ 7
4. PROGRAMMING ___________________________________________________________________ 8
4.1 SET POINTS PROGRAMMING ___________________________________________________ 8
4.2 HOW TO ENTER AND CHANGE PARAMETERS IN THE “pr1” LIST (NOT PASSWORD
PROTECTED) _________________________________________________________________ 8
4.3 HOW TO ENTER PARAMETERS IN THE “Pr2” LIST (PASSWORD PROTECTED) __________ 8
4.4 HOW TO CHANGE THE PARAMETER VALUES IN “Pr2” ______________________________ 9
4.5 HOW TO LOCK THE KEYBOARD _________________________________________________ 9
5. PARAMETERS ___________________________________________________________________ 10
6. RELAY OUTPUTS ________________________________________________________________ 14
6.1 OUTPUT SETUP AND SPECS __________________________________________________ 14
6.2 OUTPUT 1 CALL FOR HEAT (1on=rEG) ___________________________________________ 14
6.3 OUTPUT 2 2ND STAGE (oS2=Std 2on=rEG) _______________________________________ 15
6.4 OUTPUT 2 AS ALARM RELAY (oS2=AL, 2ON=REG) _________________________________ 15
6.5 OUTPUT 3 TEMPERATURE PROTECTION (3on=rEG) _______________________________ 16
6.6 OUTPUT 3 ALTERNATE SET POINT _____________________________________________ 17
7. MODULATION OUTPUT ____________________________________________________________ 18
8. MODULATION BUFFER ____________________________________________________________ 19
9. DYNAMIC RESET OF St1 __________________________________________________________ 19
10. WARM WEATHER SHUT DOWN _____________________________________________________ 19
11. HOT KEY PROGRAMMING _________________________________________________________ 20
12. ASSIGNING TEMPTRAC® ADDRESS FOR MODBUS RTU _______________________________ 21
13. ALARMS ________________________________________________________________________ 22
13.1 DIGITAL INPUT ALARMS ______________________________________________________ 23
13.2 AUDIBLE ALARM _____________________________________________________________ 23
13.3 ALARM RECOVERY __________________________________________________________ 24