11
Pairing the remote control to your adjustable bed
Your adjustable bed is already paired to your remote at the factory. Manual pairing is
only needed for replacement remote controls.
NOTE: For the pairing to be successful, make sure the distance between the control
box and the remote control is not more than 2 meters.
1
Make sure your bed is connected to a working electrical outlet. A surge protector
is recommended.
Remote control guide
3
2
Unplug the power cord from the outlet and then plug it back in. The LED light on
the control box turns blue and the control box is in remote pairing mode for 20
seconds.
On your remote control, press and hold the Flat and massage Stop buttons for four
(4) seconds.
If the pairing is successful, the LED light on the control box turns to green
immediately. If pairing fails, the LED light on the control box stays blue and
turns green only after the 20-second timeout. Repeat steps 2 to 3 until pairing is
successful.
To Next Page
Loading...
