Rize Aviada - Page 6

6 Owner’s manual | Aviada adjustable bed
Installation guide
Seing up your adjustable bed
NOTE: For safety reasons, lifting of the adjustable bed must always be performed by two (2) people; and
the unit should always be on a flat surface before opening.
1
2
Lift the adjustable bed out of the shipping carton carefully, and put it on a flat
floor with the top side facing downward.
Remove all accessory boxes and cut the orange ties from inside the adjustable
bed.
Aaching the bed legs
Take out the four (4) arch bed legs from the accessory box.
Attach the arch bed leg to the rectangular steel pipe on the bed frame. Make sure
the leg opening is facing inside the frame.
Thread a knob screw fitted with a spring washer into the first pre-drilled hole on
the rectangular steel pipe and through the arch bed leg. Hand tighten the screw
to secure it in place.
Do the same on the second pre-drilled hole on the rectangular steel pipe.
Repeat steps 2, 3, and 4 on the remaining arch bed legs.
If you want to add more height to the bed frame, attach the leg extenders to the
arch bed legs.
Thread the leg extender in a clockwise direction into the pre-threaded hole at the
end of the arch bed leg.
Hand tighten the leg extender to secure it in place.
1
2
3
4
5
6
7
Knob screw fitted with
a spring washer