7
7
Installation guide
Seing up the electronics
Locate the wires for the under-bed light from the control box (A). These should
be fastened near the rectangular steel pipe of the bed.
Then, locate the wires attached to the arch bed legs (B).
Connect the wires to each other.
Repeat steps 1 and 2 for each arch bed leg.
Remove and extend the power cord from the frame.
Turn the bed frame over carefully so the top side is now facing upward.
NOTE: Do not rest the frame on its side. The weight may damage the legs.
Plug the power cord into a working electrical outlet.
NOTE: For optimal safety, using a surge protector (not included) is highly
recommended.
Install batteries in the remote control. Try all functions on the remote to make
sure all features are operational.
NOTE: If the bed does not work, see the Troubleshooting section of this manual.
Return bed to flat position before continuing with the installation.
NOTE: Make sure your bed is in a flat position before using it. Press the FLAT
button on the remote control after plugging in the power cord.
1
2
3
4
5
6
7
IMPORTANT! Make sure power cords do not obstruct any adjustable bed mechanisms.
8
To Next Page
Loading...
