8 Owner’s manual | Aviada adjustable bed
Using the bed leg strap (optional)
Wrap the legs of the two beds together tightly. Use one leg strap for the front
legs and another strap for those at the back.
Fasten the straps to prevent movement & maintain stability.
1
2
To help prevent bed separation when using two adjustable beds together, you may use
the bed leg strap that came with each bed.
Installing the maress retainer bracket
Use the remote control to raise the foot section of the bed.
Insert one retainer bracket between the decks on the foot of the bed. Make sure
it aligns with the pre-threaded hole on the frame.
From underneath the bed frame, insert a knob screw through the pre-threaded
hole and into the retainer bracket to keep it in place. Hand tighten the screw.
Repeat steps 2 and 3 with the other retainer bracket.
1
2
Place your mattress on the adjustable bed surface. Your adjustable bed installation is
now complete.
Installation guide
3
4
IMPORTANT!
• Failure to follow the installation steps as they appear in this guide could result in damage to your adjustable bed.
• For safety reasons, lifting of the adjustable bed must always be performed by two (2) people; and the unit should always be on a flat surface.
To Next Page
Loading...
