Why does my RKI Instruments Gas Detectors LCD show abnormally high readings?
If the LCD of your RKI Instruments Gas Detector shows abnormally high readings while other instruments do not, it could be due to a calibration issue or a faulty sensor. First, recalibrate the unit. If the problem persists, replace the sensor and then recalibrate the unit.
What to do if RKI Instruments CO-01 Gas Detectors displays “FAIL” during span adjustment?
If your RKI Instruments Gas Detector displays “FAIL” during span adjustment, there might be an issue with the calibration setup. Start by checking all calibration tubing for leaks or bad connections. Ensure the 01 Series is properly set up for calibration. Also, verify that the calibration cylinder contains an adequate supply of fresh test sample. If the fail condition continues, consider replacing the sensor.
How to fix a blank LCD on RKI Instruments Gas Detectors?
If your RKI Instruments Gas Detector LCD is blank, it might simply be turned off or have drained batteries. To turn it on, press and hold the POWER/ MODE button. If it doesn't turn on, replace the alkaline batteries.
What to do if RKI Instruments CO-01 displays “FAIL SYS”?
If your RKI Instruments Gas Detector displays “FAIL SYS” on the LCD, a microprocessor failure may have occurred. Try turning the unit off and then on again.
General| Brand | RKI Instruments |
|---|---|
| Model | CO-01 |
| Category | Gas Detectors |
| Language | English |
To Next Page
