0107
8. It is forbidden to be overloaded for the electric bicycle. If it is
overloaded, the electrical parts will be damaged.( the plastic parts may
disformed for the high temperature, or the fuse socket will be damaged
for the high temperature) These are not under warranty.
9. Please cut off the power if there is problem on the electrical parts.
10. Please pay attention to national legal requirements when the bicycle
is to be ridden on public roads (e.g. lighting and reflectors)
11. The A-weighted emission sound pressure level at the driver ears
should be less than 70 dB(A).
Getting Started
First, unpack your electric bike carefully and save all packing material. Be
sure to locate your charger, pedals, keys and any small parts like nuts or
screws inside the shipping carton. Sometimes small parts like nuts or
screws may come loose during shipping so be sure and check the bottom
of the carton and protective wrapping carefully. Keep your packing
material until you are through assembling your bike and know that it is
running properly.
Sometimes small parts like nuts or screws may come loose during
shipping so be sure and check the bottom of the carton and protective
wrapping
Assembly Instructions
This bicycle was fully assembled, inspected and tuned at the factory and
then partially disassembled for shipping.
Your bike arrives in the shipping carton about 90% assembled. To ship the
bike, the pedals, seat, front wheel and sometimes the handlebar are
loosened or removed.
In order to ensure the cycling safety and using performance, the fastening
requirements for the bolts of key places.
To Next Page
