5. BATTERY CHARGING AND CARE
17
SUGGESTIONS
» Make sure the terminals are installed properly and put the cover back on.
» Do not use the battery to charge telecom equipment or other items.
» Battery eciency will vary with outside conditions; the driving distances will be
shorter in the winter. If the vehicle is not used for a long time, please charge the
battery at least every week.
» Replace both batteries together.
CHARGER REPLACEMENT
» Follow procedure 1 and 2 above.
» Make a note of how the wire and socket are situated in the battery pack before you move the
charger’s wire and socket.
» Unplug the socket to remove the charger, then replace a new one.
» Situate the wire, socket and LED on the battery pack as they were originally.
CLEANING THE BATTERY
If the batteries are contaminated by water, battery acid, dust or other substances, they will discharge
quickly. The batteries supplied with the scooter are sealed and as such are maintenance free with no
risk of battery leakage. Please follow the steps below to clean the battery.
» Turn the scooter power switch to OFF.
» Remove the seat and dust cover.
» Remove the shroud and unplug the terminal of the tail light and signal lights.
» Use a clean cloth to wipe o the soiled area.
» Take out the battery.
» Clean the battery with a clean cloth. If the terminal is covered by white powder, please wipe it
clean using warm water.
WARNING
» The wiring system and charger are well situated in battery pack while assembled
in plant. Do not attempt to re-locate the wiring system by yourself. The improper
layout of wiring system may result in the wires being pinched by battery box, which
could cause the electronic system to fail.
» Be sure the battery wires are connected to their right battery terminal.
SUGGESTIONS
» If necessary, ask for help from your dealer for advice about maintaining and
replacing the battery.
To Next Page
Loading...