English English
Note: If power is interrupted the time and alarm settings will be lost. When
power is restored the clock will begin indicating 00:00 that the time
and alarm settings must be corrected.
SETTING THE CORRECT TIME
1. Press shortly the CLOCK Button (10).
2. Press the TUN/TIME+ (3) or - (4) button to advance hour
3. Press shortly the CLOCK Button (10) again.
4. Press the TUN/TIME+ (3) or - (4)button to advance MINUTE until the
correct time is displayed.
5. Press shortly the CLOCK Button(7) to complete the setting operation.
SETTING THE WAKE UP TIME
1. Set the alarm time by following this procedure:
2. Press shortly the ALARM Button (6) two times.
3. Press the TUN/TIME+ (3) or - (4) button to advance hour
4. PressshortlytheALARM Button (6) again.
5. Press the TUN/TIME+ (3) or - (4)button to advance MINUTE until the
correct time is displayed.
6. PressshortlytheALARM Button (6) again.
7. Press the TUN/TIME+ (3) or - (4) button to select the alarm mode 1
(BUZZER)or2(RADIO)
8. Press shortly the ALARM Button (6) to finish.
9. Setthe ALARM ON/OFFSelector(2) tothe activateordeactivatethe
alarm (when ON, the “ ”indicator will light up on the right side of the
display).
10. To switch off the alarmsettheALARMON/OFFSelector(2)to the OFF
position.
9. Adjustthe VOLUME (11) knob for the best Buzzer or Radio level.
LISTENING TO THE RADIO
1. Press shortly the ON/OFF/AUTO (7) button to switch the Radio ON .
2. Press shortly the ON/OFF/AUTO button again to start the Radio auto-
tuningfunction (the unit willstoreautomatically the strongeststations).
3. Adjust the VOLUME Control (15) to a comfortable listening level.
4. To turn off the radio, keep pressed the CLOCK (10) button for three
seconds.
5.To listenthe desiredRadio stations, shortpressSNOOZEbuttontoselect
the stored station.
6. To search manually a Radio station, when in RADIO mode press the
TUN- (3)orTUNE UP (4)buttonsequentially untilthedesiredfrequency
isdisplayed,then presstheSNOOZEbutton (1) to storein the memory.
Note: For FM receptionthere is a built-in FM antenna wire at the rearof
the unit. Movethe wire around to obtain the best reception.
3 4
To Next Page
Loading...
Need help?
General
