FOR UNITS WITH TIMER
Timer Functions
A. Clock
B. Timer STD/AUTO
C. Set Sleep Delay Time*
D. Set ON/OFF Times*
E. Filter Life
i. Remaining Life
ii. Filter Reset
iii. Service Menu
* ON/OFF times & Sleep Delay Time only operate in AUTO Mode.
To select a Timer Mode
Press the (Prog) button until the desired mode is displayed on the screen. Press
the (Accept) button to confirm selection. Pressing (Cancel) button at any time
returns the unit to the main menu. Any functions previously accepted will be
retained.
Note: The display will revert back to main menu from any mode if a button has not
been pressed for 1 minute.
A) Setting the Clock
Select the clock mode
(Prog>Clock>Accept)
Display Shows: “Set Clock Day”.
Press the (UP) button until the desired day appears on the screen and press the
(Accept) button to confirm selection.
Display Shows: “Set Clock HOUR”
Press the (UP) button until the desired hour (24 Hour Time) appears flashing on the
screen and press the (Accept) button to confirm selection.
Display Shows: “Set Clock MIN”
Press the (UP) button until the desired minute appears flashing on the screen.
Press the (Accept) button to confirm selection and the display reverts to the main
menu
B) Set Timer to STD/AUTO Mode
Select the Timer STD/AUTO mode (Prog>Timer STD/AUTO>Accept)
Display Shows: “STD”
Pressing the (UP) button alternates the “STD”/“AUTO” icons. STD operation means
that the unit operates 24 hours a day, Auto mode reverts the unit to operate at the
To Next Page
Loading...