Robert Smart R-909 - Automatic Code Search

IMPORTANT: write down the correct code on the label under the battery
cover. Thus, if needed, you can nd it quickly and simply.
Point the remote towards the
controllable device and check
that the keys of the remote are
working. If some or all of the main
keys are not working, repeat steps
2 ~ 4 and try other codes from
the list until all the main keys are
working properly.
Manually switch on the TV.
As with the 'Code setup from the
code table' method, the device
must be fully switched on, and not
just in standby mode!
B. AUTOMATIC CODE SEARCH
Use automatic code search if you have tried 'Code setup from the code
table', but the device cannot be controlled yet. This function ensures
selection of code from an even wider code list entered in the remote
control memory so that the remote can also be programmed for more
specic models.
Press key [SET] on the remote
and keep it pressed; press also
key [POWER] and keep both keys
pressed for 5 seconds. Release
both keys as soon as the light
indicator comes on and starts
to ash irregularly. From this
moment automatic code search
mode will have switched on. If
the light indicator is in any other
state, repeat the abovementioned
operations until the indicator
starts to shine and ash brightly.
Transmission of switch-o code
will begin.
The indicating light is on
- 5 -
34-240