Roberts 10-60 - Set Up; Installation of the Cutter; Working Table

- 2 -
1. INSTALLATION OF THE CUTTER
Install the cross bar to the cutter base
with provided bolt as shown.
WARNING: Do not put your fingers
against the sharp edge of the blade at
any time.
2. INSTALLATION OF THE CUTTER
Insert the handle to the base and install
the rear base to the front base with
provided screws as shown.
WARNING: Do not put your fingers
against the sharp edge of the blade at
any time.
3. WORKING TABLE
Install the working table as shown.
WARNING: Do not put your fingers
against the sharp edge of the blade at
any time.
SET UP