Roberts Blutune 5 - Manual tuning - DAB; Dynamic Range Control (DRC) settings - DAB; Prune stations - DAB

9
Manual tuning - DAB
Manual tuning allows you to tune your radio to a particular DAB frequency
in Band III. Any new stations found will be added to the station list. This
function can also be used to assist the positioning of the aerial or the radio
WRRSWLPLVHUHFHSWLRQIRUDVSHFL¿FFKDQQHORUIUHTXHQF\
1. Press Mode until the 'DAB' mode is selected.
2. Press Menu. Rotate Tuning until 'MANUAL' is displayed. Press Tuning.
3. Rotate Tuning to select the desired DAB channel. Press Tuning to
tune to the chosen frequency.
4. If a signal is present, this will be indicated on a signal strength display.
The minimum signal marker (
) shows the minimum signal strength
needed for good DAB reception.
5. When a DAB signal is found, as shown by the signal indicator chevrons,
any new radio stations found with this signal will be added to the list
stored in the radio.
6. Press Tuning and then Menu to exit.
Dynamic Range Control (DRC) settings - DAB
The DRC facillity can make quieter sounds easier to hear when your radio
is used in a noisy environment.
1. When in DAB mode, press Menu.
2. Rotate Tuning until 'DRC' is displayed. Press Tuning.
3. Rotate Tuning to select the required DRC setting.
DRC 0 - DRC is switched off, Broadcast DRC will be ignored. DRC
1/2 - DRC level is set to 1/2 that sent by broadcaster. DRC 1 - DRC is
set as sent by broadcaster.
4. Press Tuning WRFRQ¿UPWKHVHWWLQJNote: Not all DAB broadcasts use
the DRC function. If the broadcast does not provide DRC information,
then the DRC setting in the radio will have no effect.
DAB
DAB
DAB
DAB
DAB