Roberts Blutune 5 - Manual tuning - FM; FM Stereo; Mono; Scan sensitivity setting - FM

11
Manual tuning - FM
1. Rotate Tuning to tune to a station.The frequency will change in steps of
50kHz.
2. Adjust the Volume.
FM Stereo / Mono
 ,IDQ)0VWDWLRQEHLQJUHFHLYHGLVZHDNVRPHKLVVPD\EHDXGLEOH7R
reduce this, press Menu and then rotate Tuning until the display shows
'AUDIO'. Press Tuning.
2. Rotate Tuning until 'MONO' is displayed. Press Tuning. Your radio will
switch to mono mode.
3. To return to stereo mode rotate Tuning until 'STEREO' is displayed. Press
Tuning. Your radio will switch to stereo mode.
FM
FM
Scan sensitivity setting - FM
<RXUUDGLRZLOOQRUPDOO\VFDQIRU)0EURDGFDVWVZKLFKDUHVWURQJHQRXJKWR
give good reception. However, you may wish the Auto-scan function to also
EHDEOHWR¿QGZHDNHUVLJQDOVSRVVLEO\IURPPRUHGLVWDQWUDGLRWUDQVPLWWHUV
Your radio includes a local / distant option for the Auto-scan function.
 :KHQLQ)0PRGHSUHVVMenu.
2. Rotate Tuning until 'SETTING' is displayed. Press Tuning.
3. Rotate Tuning to choose either the 'LOCAL' or 'DISTANT' option. The
'LVWDQWRSWLRQZLOODOORZWKHUDGLRWR¿QGZHDNHUVLJQDOVZKHQVFDQQLQJ
4. Press Tuning WRFRQ¿UP7KH/RFDORU'LVWDQWVHWWLQJLVVWRUHGLQWKHUDGLR
and remains in force until changed or until a System Reset.
Note: The initial setting (out of the box, or after a System Reset) causes
the radio to ignore weaker (or more distant) signals.
FM
FM
FM
FM