Roberts Blutune 5 - Using the radio for the first time

6
8VLQJWKHUDGLRIRUWKH¿UVWWLPH
1. Plug the mains adaptor into the DC input socket located on the rear of your
radio (marked 'DC') ensuring that the plug is pushed fully into the socket.
 3ODFH\RXUUDGLRRQDÀDWVXUIDFH
3. Carefully extend the telescopic aerial. The aerial should be fully extended
and positioned vertically for optimum reception.
4. Plug the other end of the mains adaptor into a standard mains socket
outlet and switch on the wall socket.
5. The display will show 'WELCOME' for a few seconds. During this time the
UDGLRLVVFDQQLQJWR¿QGD'$%UDGLRVLJQDO$IWHUDVKRUWWLPHWKHFXUUHQW
time and day will appear on the display.
6. If no signal is found, 0:00 will continue to be displayed. It may be necessary
to relocate your radio to a position giving better reception. You should then
FDUU\RXWDVFDQWR¿QGVWDWLRQVVHH)LQGLQJQHZVWDWLRQVRQSDJH
7KH$&DGDSWRUVKRXOGEHGLVFRQQHFWHGIURPWKHPDLQVVXSSO\DQGIURPWKH
radio when not in use.
IMPORTANT: The mains adaptor is used as the means of connecting the
product to the mains supply. The mains socket and any multi-way mains block
used for the product must remain accessible during normal use. In order to
disconnect the product from the mains, the mains adaptor should be removed
from the mains socket completely.
Use only the mains adaptor provided with the product, or a genuine replacement
provided by Roberts Radio. The use of alternative adaptors will invalidate the
guarantee.
Aux In
DC IN
9V
1A
OPEN