Roberts Stream 218 - Demonstration Mode; Factory Reset

63
Information
Demonstration mode
If your radio has been supplied with demonstration mode enabled most operations
will display a message 'Inactive in demo mode'. This may be cancelled completely
by carrying out a factory reset operation as described below.
Factory reset
If you wish to completely reset your radio to its initial state this may be performed
by following this procedure. By performing a factory reset, all user entered settings
will be erased.
1. With your radio switched on, Press Menu.
2. Choose 'Main menu', 'System settings', 'Factory Reset' and then 'YES' to
proceed.
If you do not wish to carry out a system reset, highlight 'NO' and then press
the control. The display will revert to the previous menu.
3. With 'YES' highlighted, press Tuning. A full reset will be performed and the
UDGLRZLOOUHVWDUWDVLI¿UVWSOXJJHGLQ7KH'$%VWDWLRQVOLVWWRJHWKHUZLWKDQ\
preset stations will be erased and your wireless network connection details
ZLOOEH ORVW$OO FRQ¿JXUDWLRQVHWWLQJVZLOOEHUHVWRUHGWR WKHLUGHIDXOWVWKH
clock and alarms will be reset.
Factory reset
Proceed?
Equaliser
Network
Time/Date
Brightness
Language
Factory Reset
System settings
(OHFWURPDJQHWLFFRPSDWLELOLW\DGYLFH
In the event of a malfunction due to electrostatic discharge, mains power supply
transients or short interruptions, reset the product as above to resume normal
operation. If you are not able to perform the reset operation as above, removal
and reconnection of the power supply and batteries may be required.
If the product is used in an environment with any ESD Immunity / Radiated
Immunity / Conducted Immunity disturbance, the product may malfunction. It will
automatically recover to normal when the ESD Immunity / Radiated Immunity /
Conducted Immunity disturbance is stopped.
3URGXFWPDUNLQJV
'&9ROWDJH
3RZHULQSXW9$
86%RXWSXW9P$
5HF\FOLQJ
This product bears the selective sorting symbol for
Waste Electrical and Electronic Equipment (WEEE).
This means that this product must be handled
pursuant to European directive 2012/19/EU in order
to be recycled or dismantled to minimize its impact on
the environment.
The user has the choice to give the product to a
competent recycling organization or to the retailer
when buying a new electrical or electronic equipment.