Results
The test results are displayed on the display screen, showing the actual measured values, or when necessary
the reason for failure, eg Fuse Blown. The result may also be stored internally in a non-volatile memory,
this data is instantly available for review, printing or data transfers if required. The displayed or stored
results may be printed out by an external printer. The records will contain the site, date and appliance
being tested as well as the type of test performed.The results may also be recorded in other mediums, by
entering them in a Portable Appliance Test Log Book (Robin Manual IRPI ) or downloading the results
into a computer with a compatable PAT database management software such as Robin PowerPAT Plus
Data Management software. Both the IRPI log book and PowerPAT Plus software are available as optional
accessories from Robin Electronics.
INSTALLATION
Power Requirements
WARNING
LETHAL VOLTAGES. THE SmartPAT 5500 CONTAINS HAZARDOUS VOLTAGES,
CORRECT HIGH VOLTAGE HANDLING PRECAUTIONS MUST BE OBSERVED
AT ALL TIMES.
The power requirements of the SmartPAT 5500 are detailed under the Technical Specifications.
The Appliance Tester is dispatched from the factory with a mains lead carrying a 230V plug. To power the
Test Set from 110V requires the use of an adaptor. The adaptor is available from Robin as:
AD 110V 110V Adaptor.
Connections
WARNING
ELECTRIC SHOCK. TO AVOID ELECTRIC SHOCK, ENSURE THAT ALL POWER IS OFF AND ALL
DEVICES ARE UNPLUGGED BEFORE CONNECTING OR REMOVING ANY OF THE TEST CABLES.
CAUTIONS
EQUIPMENT DAMAGE. The equipment has been set for a nominal 230V/110V operation, it must never
be connected to a higher voltage.
EQUIPMENT DAMAGE. The mains supply is never to be connected to the IEC lead test connector.
The only connection to be made prior to commencing testing is to plug the SmartPAT 5500 into the
correct power source.
SmartPAT 5500
9
7681 - 5500 PAT Manual 2002 7/26/02 11:14 AM Page 11
To Next Page
Loading...