SmartPAT 5500
Programming
The programme mode has a number of functions, the major functions require the entry of an access code
before the tester will allow that function to be actioned.
The access code is set at the factory to 9999.
Press the PROG key, the following screen is displayed:
Enter or change an
autotest? YES/NO
To select the programming mode required or to view the selection of modes available press NO. At each
screen as it is displayed press NO to view the next mode.
Set communications
speed ? YES/NO
Set floppy storage
format ? YES/NO
Set up Professional/
Normal mode ? YES/NO
Set up Diagnostic
test lockout ? YES/NO
Change access code ?
YES/NO
Selecting NO at the last choice reverts to programming mode opening screen
Autotest
Enter or change an
autotest? YES/NO
Press YES to perform this function.
Enter access code
….
Enter access code, then press GO, the following is displayed:
Enter a new autotest
number to edit or
the message continues on the second screen.
An existing autotest
number to copy
After a few seconds the following screen is displayed:
Autotest number: . . .
If the number entered is not of the correct format the screen will flash with the message Invalid
autotest. On completion press GO. The unit will now ask you to assign a copied autotest sequence a
new number, eg 107. On completion press GO.
20
7681 - 5500 PAT Manual 2002 7/26/02 11:14 AM Page 22
To Next Page