SmartPAT 5500
A new autotest may now be programmed or an existing test edited to suit the testing requirements, it will
be assigned the new autotest number, eg 107. Use the up/down arrow keys to run through the various
test parameters. The screen will display steps to be taken to select or skip parameters to be included or
omitted from the new autotest number.
The values within each parameter test sequence, for example if you wish to include an Earth Bond Test
you can change the value of that current, the pass level and the test time duration by using the
CURRENT, LEVEL, CLASS and TIME keys
On completion the screen displays:
Use Review/Store to
Review/Save Autotest
Pressing the REVIEW key will allow you to scroll through the test sequence you have selected. If all the
details are correct press STORE, the screen will display:
Autotest Stored
In Number....………….107
This new autotest can now be selected in future tests using autotest code 107.
Communication Speed
Set communications
speed ? YES/NO
Press YES to perform this function.
Use UP/DOWN then GO
Speed: 9600bps
Use the UP/DOWN controls to select the speed required for the interface. The range is:
1200bps
2400bps
4800bps
9600bps
On completion press GO, the following is displayed to confirm the speed has been set:
Speed: 4800bps
Press STOP to return to main menu
21
7681 - 5500 PAT Manual 2002 7/26/02 11:14 AM Page 23
To Next Page
Loading...