9
Cleaning and Maintenance
BULB REPLACEMENT
Important:
• The bulb must be replaced by the manufacturer, its service agent, or similarly qualified persons.
• Always switch off the electricity supply before carrying out any operations on the appliance. When handling
bulb, make sure it has completely cooled down before any direct contact with hands.
• When handling bulbs hold with a cloth or gloves to ensure perspiration does not meet the bulb as this can
reduce the life of the bulb.
Note:
• Before changing the lights, make sure that the appliance is turned off and unplugged.
• Protect against danger when changing lights, such as wearing gloves.
Changing the lights:
• Switch off the appliance and unplug it.
• Unscrew the 4 screws on the outer glass frame panel by screwdriver.
• Pull out the light wire and switch wire, take down the outer glass frame panel.
• Unscrew the screws on the light bracket and replace the lights.
• Apply the reverse procedure to install the light back.
1. ILCOS D code for this lamp is: DSS‐1.5/65‐S‐120/33
2. LED modules –LED light strip
3. Max wattage: 2×1.5W
4. Voltage range: DC 12V
Dimensions:
To Next Page
Loading...
