7
Troubleshooting
Fault Possible Cause Solution
Light on, but motor
does not work
Select a fan switch position.
Light does not work;
motor does not work
Mains power cable is loose or
disconnected
Refit mains power cable to power
outlet.
Switch power outlet on.
Oil leakage
One way valve and the outlet are
not tightly sealed
Take down the one-way valve and
seal with sealant.
Leakage from the connection of
chimney and cover
Take chimney down and seal.
Lights not working Broken or faulty bulbs
Replace bulbs as per this
instruction.
Insufficient suction
The distance between the cooker
hood and the gas top is too far
Refit the cooker hood to the correct
distance.
inclines
The fixing screw is not tight
enough
Tighten the hanging screw and
make it horizontal.
NOTE:
Any electrical repairs to this appliance must conform to your local, state and federal laws. Please contact the service
center if in any doubt before undertaking any of the above. Always disconnect the unit from the power source when
opening the unit.
To Next Page
Loading...
