You can set the maximum temperature at which the
charger should allow battery to reach during charge.
Once a battery reaches this temperature during
charge, the process will be terminated to protect the
battery.
The battery is on the cyclic process of charge and
discharge can often become warm after charge or
discharge period. The program can insert a time
delay to occur after each charge and discharge
process to allow the battery adequate time to cool
down before being subjected to the next process.
The value ranges from 1 to 60 minutes.
When you start a charge process, the integral safety
timer automatically starts running at the same time.
This is programmed to prevent over charge the
battery if it proves to be faulty, or if the termination
circuit cannot detect the battery full. The value for
the safety timer should be generous enough to allow
a full charge of the battery.
This program sets the maximum charge capacity that
will be supplied to the battery during charge. If the
delta-pack voltage is not detected or the safety timer
expired by any reason, this feature will automatically
stop the process at the selected capacity value.
The beep sounds at every time pressing the buttons
to confirm your action. The beep or melody sounded
at various times during operation to alert different
mode changes. These audible sounds can be on or
off.
Temp Cut-Off
ON 80C 176F
-8-
Waste time
CHG/DCHG 5min
Safety timer
ON 240min
Capacity Cut-off
ON 10000mAh
Key Beep ON
Buzzer ON
To Next Page
Loading...
