To Next PageTo Next Page
Need help?Do you have a question about the Robitronic Expert LD60 and is the answer not in the manual?
Enhances safety and control with automatic parameter adjustment.
Balances individual Lithium battery cells during charging without external devices.
Implements Delta-peak, capacity, temperature, and time limits for safe operation.
Covers unattended charging, environmental conditions, and proper setup surfaces.
Details voltage levels and charge/discharge limits for various battery chemistries.
Sets the time for automatic cell count detection in Lithium batteries.
Defines the maximum battery temperature for charging termination.
Establishes an overall time limit to prevent overcharging.
Sets charge current and voltage for various Lithium battery types.
Balances individual cell voltages during the charging process.
Reduces charging time by shortening the constant voltage (CV) phase.
Sets discharge current and final voltage for Lithium batteries.
Sets charge current limit and charge mode for NiCd/NiMH batteries.
Sets discharge current and final voltage for NiCd/NiMH batteries.
Sets charge current and nominal voltage for lead-acid batteries.
Sets discharge current and final voltage for lead-acid batteries.
General| Charge Current | 0.1-6.0A |
|---|---|
| Discharge Current | 0.1-2.0A |
| Charge Power | 60W |
| NiCd/NiMH Cells | 1-15 cells |
| LiPo/LiFe/LiIon Cells | 1-6 cells |
| Pb Battery Voltage | 2-20V |
| Memory Slots | 10 |
| Input Voltage | 100-240V AC or 11-18V DC |
| Battery Types | LiPo, LiFe, LiIon, NiMH, NiCd, Pb |
| Cell Count (LiPo/Li-ion) | 1-6 |
| Cell Count (LiFe) | 1-6 |
| Cooling | Built-in fan |
| Dimensions | 135x112x60mm |
