6.3 `FAST´charging Lithium batteries
The charging current is getting smaller as the process goes to the near end term
of Lithium battery charging. To finish charging process earlier, this program
eliminate certain term of CV process. Actually, the charging current will goes to
1/5 from the initial value to end the process while the normal charging goes to
1/10 during CV term. The charging capacity may be a bit smaller than normal
charging but the process time will be reduced.
6.4 'STORAGE' control Lithium battery
This is for charging or discharging Lithium battery not to be used for the time
being. The program will determine to charge or discharge the battery to the
certain voltage depending on the voltage of the battery at its initial stage. They
are different from the type of the battery, 3.70V for Lilo, 3.80V for LiPo, 3.85V for
LiHv and 3.3V for LiFe per cell. If the voltage of battery at its initial stage is over
the voltage level to storage, the program will start to discharge.
You can set up the charging current and the voltage of
the battery pack being charged. As you press Start/
Enter button the voltage confirmation will be displayed.
And then, if you confirm the voltage and current, press
Start/ Enter button again to start charging.
This shows the present state of 'FAST' charging. To
stop charging arbitrary, press Batt .type/Stop key once.
You can set up the current and the voltage of the
battery pack to be charged. The current will be used
for charge or discharge the battery to reach the
'storage' level of voltage.
The screen shows the present situation during
charge process. To stop charging press
Batt type/Stop key once.
LiPo[0] FAST CHG
2.0A 11.1V(3S)
-11-
Li3S 2.0A 12.59V
FAS 022:43 00682
LiPo[0] STORAGE
1.0A 11.1V(3S)
Li3S 2.0A 12.59V
STO 022:43 00682
To Next Page
Loading...
