Robomow RC308u User Manual (English)

Other manuals for Robomow RC308u

Questions and Answers:

M
melissalongAug 13, 2025
Why is my Robomow RC308u Lawn Mower showing 'No Wire Signal'?
- J
  Jodi HernandezAug 14, 2025
  The 'No Wire Signal' error on your Robomow Lawn Mower can occur for several reasons: * The Power Box/Perimeter Switch might not be turned on or properly connected. Ensure the Base Station is connected to the mains supply. * The Power Box may need a restart. Disconnect it from the mains power and reconnect after 10 seconds. * The Perimeter Wire might not be correctly connected to the Base Station/Perimeter Switch. Verify the low voltage cable between the Power Box and the Base Station is connected. * The Perimeter Wire might be cut. Inspect the installation for any cuts and repair the broken cable using the waterproofed connector supplied in the box.
M
marialarsenAug 17, 2025
What to do if my Robomow RC308u is stuck in place?
- A
  Andrew YoungAug 17, 2025
  If your Robomow Lawn Mower is stuck, here's what you can do: * Move the mower from its current location and restart it. * If the drive wheel motors have been working under a severe load, determine and fix the reason it got stuck. * If the front wheel is blocked by a ditch or uneven ground, check the area around the mower. Fill any ditches or level the ground. * Check that the drive wheels can rotate freely and nothing is blocking them. If needed, increase the cutting height if it's too low for the grass.
K
Kevin HarrisAug 21, 2025
What to do if my Robomow Lawn Mower is outside the designated area?
- C
  crodriguezAug 21, 2025
  If your Robomow Lawn Mower is operating outside the designated area, consider these potential causes: * The Perimeter Wire might be too close to the lawn's edge. Move the wire towards the inner side of the lawn. * The Perimeter Wire might have been laid incorrectly around a perimeter island. Ensure it is laid according to the manual's instructions. * The lawn slope might be too steep along the edge. Avoid including areas with very steep slopes. * The cutting height might be set too low, preventing the mower from turning correctly. Increase the cutting height. * Automatic operation might have started while the robot was outside the Perimeter Wire loop. Place the mower inside the lawn and restart operation.

Robomow RC308u Specifications

General

Type	Robotic lawn mower
Noise level	69 dB
Cutting width	280 mm
Grass catcher	-
Product color	Green
Cutting system	Rotary blades
Number of wheels	3 wheel(s)
Maximum working climb	36 %
Recommended lawn area	800 m²
Maximum cutting height	60 mm
Minimum cutting height	15 mm
Grass collecting volume	- L
Cutting clearance adjustment	6
Battery type	Built-in
Power source	Battery
Charging time	1.5 h
Battery voltage	26 V
Battery capacity	3 Ah
Battery life (max)	70 min
Battery technology	Lithium
Power consumption per month (max)	18 kWh