08
B1
Positioning the Dock
Notes:
• When using the robot for the first time, follow it
throughout its whole cleaning route and watch for
potential problems. The robot will be able to clean by
itself in future uses.
• To prevent excessive buildup of dirt on the mop cloth,
floors should be vacuumed at least three times before
the first mopping cycle.
Notes:
• Keep at least 0.5 m (1.6 ft) of clearance on either side,
1.0 m (3.3 ft) in front.
• If the power cord hangs vertically to the ground, it
may be caught by the robot, causing the dock to be
moved or disconnected.
• Keep the dock away from direct sunlight or anything
that may block the dock location beacon, otherwise
the robot may fail to return to the dock.
Notes:
• Always place the moisture-proof mat on wooden
floors.
• When necessary, remove the double-sided adhesive
tape slowly to reduce residue glue.
• The moisture-proof mat attaches best to smooth
surfaces.
Notes:
• The robot may not be turned on when the battery
is low. In this case, place the robot to the dock for
charging.
• The robot cannot be turned off when it is being
charged.
1. Tidy cords, hard or sharp objects (such as
nails and glass), and loose items from the
ground and move any unstable, fragile,
precious, or dangerous items to prevent
personal injury or property damage due
to items becoming tangled in, struck by,
or knocked over by the robot.
2. When using the robot in a raised area
(such as in a duplex apartment), always
use a physical security barrier to prevent
accidental falls that may result in
personal injury or property damage.
Place the dock on a hard, flat floor, flat
against a wall. Connect the adapter with the
After fixing the charging dock in place, use a
dry cloth to clean the area where the
moisture-proof mat will be located. Tear off
the double-sided tape at the bottom of the
moisture-proof mat, and stick the mat on the
floor.
Before using, be sure to remove the film on
the dock locators on the front of and at the
rear of the robot. Press and hold
to power
on the robot. Wait until the power indicator
Attach the Moisture-Proof Mat
B2
B3
Powering On & Charging
B4
Starting Mopping
B1-1—More than 0.5 m (1.6 ft)
B1-2— More than 1.0 m (3.3 ft)
To prevent excessive buildup of dirt on the mop
cloth, floors should be vacuumed at least three times
before the first mopping cycle.
Note:
Remove the dustbin and water tank
combo unit, open the water tank
stopper, and fill the water tank with
tap water before reinstalling the
stopper. Do not immerse the unit
into the water directly.
B4-1—
Dampen the mop cloth and wring it
until it stops dripping. Insert the
mop to the bottom of the mop cloth
attachment slot and stick it firmly.
B4-2—
Align the mop cloth mount with the
bottom of the combo unit and slide
it in until it clicks into place.
B4-3—
After the robot finishes cleaning and
returns to the dock, press two
latches of the mop cloth mount
inwards with both hands and pull
backwards to remove the mop cloth
mount.
B4-4—
dock and tidy up the excess cord. Make
sure that the location has good WiFi
coverage for a better experience with the
mobile app. Plug in and make sure that the
status indicator light is on.
light is steady white, and then place the
robot to the dock. The robot is equipped
with a built-in high-performance lithium-ion
rechargeable battery pack. To maintain
battery performance, keep the robot
charged.
B3-1—Power Indicator Light
To Next Page
