11
Notes:
•
After cleaning, always remove the mop cloth to prevent
dirty water from leaching back into the clean water tank.
•
A dirty mop cloth will compromise the washing
performance. Clean it before use.
Notes:
•
Before removing the battery, make sure it is fully drained.
Do not attempt to remove the battery if the robot is
connected to the dock.
•
Remove the entire battery pack. Avoid damaging the
battery pack casing to avoid short-circuits or leakage of
hazardous substances.
•
In the event of accidental contact with battery uid, rinse
thoroughly with water and seek immediate medical care.
Note: If the robot will be left unused for a long period, turn it
o and charge it at least every three months to avoid battery
damage caused by over-discharge.
C7
Mop Cloth
C7-1—Remove the mop cloth from the
mopping module. Wash and air dry
the mop cloth.
* Clean after each use and replace every 3 to 6 months
C8-1—Mop Attachment Slot
* Replace them every 1 to 3 months
C8
Filter Components
Note: To ensure cleaning performance, replace the lter
components every 1 to 3 months, depending on the water
quality and how often you use the robot.
C9
Charging Contact Areas
Clean the charging contacts of the dock and
the robot with a soft, dry cloth.
1. Move your nger along the notch to
remove each lter.
2. Insert new lter components and make
sure they are properly installed.
Battery
Removing the Battery
The robot is equipped with a high-performance
lithium-ion rechargeable battery pack. To
maintain battery performance, keep the robot
charged during normal use.
* Clean every month
Environment
Protection Information
* The following information applies only when disposing of the
robot and should not be followed for day-to-day operations.
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution. Remove
the battery before disposing of this product
and hand it to a professional battery
recycling facility for centralized disposal.
1. Operate the robot without connecting to
the dock until it runs out of battery.
2. Turn o the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the latch to pull out the battery
connector and remove the battery.
Basic Parameters
Robot
Note: The serial number is on a sticker on the underside of
the robot.
< 6 hoursCharging Time
Q400RR
Model
14.4V/5200mAh lithium-
ion battery
Battery
Approx. 3.2kg (7.05 lbs. )Weight
20V
1.2A
Rated Input
Charging Dock
14.4V/5200mAh lithium-
ion battery
Charging Battery
CDZ11RR or CDZ12RRModel
28WRated Power
100-240V~Rated Input
Rated Output
50-60HzRated Frequency
20V
1.2A
To Next Page
Loading...
