10
Routine Maintenance
C
C1
Main Brush
* Clean every 2 weeks and replace every 6-12 months
C1-1—Main Brush Cover
C1-2—Latches
C1-3—Main Brush
C1-4—Main Brush Caps
C1-5—Main Brush Bearing
C1-6—Turn over the robot and press the
latches to remove the main brush cover.
C1-8—Rotate the main brush caps in
the indicated unlock direction to
remove the caps.
C1-9—After removing the tangled hair or
dirt at both ends of the main brush,
reinstall it, press on the main brush
cover to lock it in place. Make sure that
the main brush cover has been properly
attached. When properly installed, all
four tabs should be hidden.
Notes:
•
Main brush should be wiped down with wet cloth and left to
dry away from direct sunlight.
•
Do not use corrosive cleaning uid or disinfectant to clean
the main brush.
C2
Side Brush
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
Reinstall the brush and tighten the screw.
* Clean every month and replace every 3 to 6 months
C3
Omni-Directional Wheel
The omni-directional wheel bracket cannot be removed.Note:
C3-1—Use a tool, such as a small screwdriver, to
pry out the axle and take out the wheel.
* Clean as needed
C1-7—Pull out the main brush and remove
the main brush bearing.
Note: Features and details of the app may vary slightly due to
the continuous app development and updates.
Cleaning Mode Switch
•
4-Level Suction Power
Robot Information
•
Cleaning History
•
Battery Level
•
Care & Maintenance
More Features
•
Firmware Upgrade
•
Volume Adjustment
•
DND Mode
•
Voice Assistance Support
C3-2—Rinse the wheel and the axle with
water to remove any hair and dirt.
Air-dry, reinstall, and press the wheel
and axle back in place.
Clean the main wheels with a soft, dry cloth.
C4
Main Wheels
* Clean every month
C5-2—Remove the washable lter and
empty the dustbin.
C5-1—Open the upper cover of the robot
and take out the dustbin.
C5
Dustbin and Washable Filter
* Clean every week and lter should be replaced every 6-12
months.
Note: To prevent blockage, only use clean water without any
cleaning liquid.
Note: Do not touch the surface of the lter with your hands,
brush, or hard objects to avoid potential damage.
C5-3—Fill the dustbin with clean water.
Gently shake the dustbin, and then
pour out the dirty water.
C5-4—Rinse the washable lter repeatedly
and tap it to remove as much dirt as
possible.
C5-5—Leave the dustbin and the washable
lter to dry and reinstall them.
C6
Robot Sensors
* Clean every month
C6-1—Dock Locator
C6-2—Wall Sensor
C6-3—Four Cli Sensors
Use a soft, dry cloth to wipe all sensors,
including:
To Next Page
Loading...
