Roborock Q7 User Manual

09
Note: Placing a paused robot on the dock manually will end
the current cleanup.
Note: After resetting is complete, WiFi and other settings will
be restored to factory defaults.
Note: After spot cleaning, the robot will automatically return
to the starting point and enter Standby mode.
Press any button to stop the robot during
operation. Press the
button to resume
cleanup. Press the
button to send the
robot back to the dock and end the current
cleanup.
Pause
If the robot is paused for over 10 minutes,
it will go to sleep, and the power indicator
will ash every few seconds. Press any
button to wake it up.
Sleep
Notes:
•
The robot will not go to sleep when it is charging.
•
The robot will automatically shut down if left in sleep mode
for more than 12 hours.
Charging
Automatically: After cleaning, the robot will
automatically return to the dock to charge.
Manually: In pause mode, press the
button
to send the robot back to the dock.
The power indicator light pulses during charging.
Note: If the robot fails to nd the dock, it will automatically
return to its starting location. Place the robot on the dock
manually to recharge.
Error
If an error occurs while the robot is cleaning,
the power indicator will ash red and a voice
alert will sound. See “Errors” for solutions.
Spot Cleaning
Press and hold the
button to start spot
cleaning. Cleaning range: The robot cleans
a 1.5 m (4.9 ft) x 1.5 m (4.9 ft) square area
centered on itself.
Resetting
If the robot does not respond when a
button is pressed or cannot be turned o,
reset the system. Press the Reset button,
and the robot will reset automatically.
Restoring Factory Settings
Notes:
•
The robot will go to sleep automatically if left in an Error
state for over 10 minutes.
•
Placing the robot on the dock in an Error state will stop the
current cleanup.
If the robot does not function properly after
a system reset, switch it on. Press and hold
the
button and at the same time press
Reset button until you hear the “Restoring
factory settings” voice prompt. The robot
will then be restored to factory settings.
App Features
Cleaning Map
•
Multi-Map Management
•
Real-Time Vacuum and Mop Route
•
Map Zoning
•
Map Editing
Custom Cleaning Modes
•
Scheduled Cleaning
•
Selective Room Cleaning
•
Zone Cleaning
•
No-Go Zones & Invisible Wall
•
Custom Modes
•
Carpet Boost
Relling the Water Tank or
Washing Mop Cloth
To add water or clean the mop cloth, press
any button to stop the robot and remove
the mopping module. After adding water
or cleaning the mop cloth, reinstall the
mopping module and press the
button
to continue.
Do Not Disturb (DND) Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND mode is activated, the
robot will not automatically resume cleanup,
the power indicator light will dim, and the
volume of the voice prompts will lower.

Roborock Q7 Specifications

General

Shape	Round
Product color	Black
Remotely operated	Yes
Dust container type	Bagless
Brush type	Roller brush
HEPA class	HEPA 11
Noise level	- dB
Navigation type	3D Smart Navigation
Water tank capacity	0.3 L
Vacuum air filtering	HEPA
Dust capacity (total)	- L
Base station functions	Charging
Dust capacity (vacuum cleaner)	0.46 L
Battery capacity	5200 mAh
Battery technology	-
Suction power	2700 Pa

Weight and Dimensions

Depth	96.5 mm
Width	350 mm
Height	353 mm
Weight	3700 g