Name: Roborock S4 Max
Brand: Roborock
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Routine maintenance

Using the main brush cleaning tool

Use the main brush cleaning tool to remove any hair entangled

around the main brush.

Dustbin and lter

*Weekly cleaning is recommended

1. Open the top cover of the robot, squeeze the dustbin latch, and

remove the dustbin.

Main brush

*Clean weekly

Note:

If there is a large amount of hair, or hair is tightly entangled, remove it carefully to

avoid damage to the main brush.

1. Turn the robot over then unlatch and remove the main brush

cover.

2. Take out the main brush, remove and clean its bearings.

3. Remove the main brush cap, rotating in the unlock direction.

4. Use the supplied main brush cleaning tool to remove any

entangled hair.

5. Re-install the cap and bearings following the lock direction.

6. Re-insert the main brush and secure the brush cover.

Note:

Main brush replacement every 6-12 months is recommended.

Lock direction

Unlock direction

Main brush bearing

Alignment mark

Main brush cover

Latch

Main brush

Main brush cap

Questions and Answers:

Need help?

Do you have a question about the Roborock S4 Max and is the answer not in the manual?

Roborock S4 Max Specifications

General