Roborock S6 User Manual

Installation
Using the mop
16
Refill the water tank
3
Open the water tank, fill the tank with water, then reseal it
carefully.
Install the mopping module
4
Line the mopping module up with the alignment indicators
on the rear of the Main Unit then slot it in until you hear
a click.
Note: Some floor cleaners or disinfectants may block the water filters.
6. Start cleaning
When the power light changes from a slow white flash to a
steady light, charging is complete. Press the buon
or use the Xiaomi Home app to start cleaning.
7. Remove the mopping module
When a cleaning cycle is complete and the main unit has
returned to the charging dock, press the latches on either
side of the mopping module and pull backwards to remove it.
Notes:
Remove the mopping module if the product is to be le unused. Empty any water
le in the water tank and clean the mopping cloth to prevent mildew or odors.
If the charging dock is placed on a wood floor, always use the damp-proof mat
to avoid moisture leaking to the floor.

Roborock S6 Specifications

General

Shape	Round
Product color	White
Remotely operated	Yes
Dust container type	Bagless
Noise level	58 dB
Integrated sensors	Accelerometer, Infrared sensor
Number of programs	14
Dust capacity (total)	0.48 L
HEPA filtration system	-
Floor surfaces supported	Carpet, Hard floor
Threshold climbing (max)	20 mm
Battery life	250 m²
Battery capacity	5200 mAh
Power consumption (typical)	58 W

Weight and Dimensions

Depth	350 mm
Width	353 mm
Height	96.5 mm