Roborock S6 User Manual

21
Routine Maintenance
Main brush
1. Flip the main unit over and push the latch to remove the main
brush cover.
2. Li the main brush out then remove and clean the bearing.
3. Rotate in the indicated unlock direction and remove the main
brush cover.
4. Use the supplied brush cleaning tool to cut anything entangling
the main brush or its bearing.
5. Re-install the main brush cover and the main brush bearing
according to the lock direction.
6. Re-insert the main brush and press the main brush cover back
in until it is locked in place by the latch.
Clean weekly
*
Note: Replacing the main brush every 6-12 months is recommended for maximum
cleaning.
Using the main brush cleaning tool
Main brush
cover
Main brush
latch
Main brush
cap
Main brush
Main brush
bearing
Alignment
indicator
Lock indicator
Unlock indicator

Roborock S6 Specifications

General

Shape	Round
Product color	White
Remotely operated	Yes
Dust container type	Bagless
Noise level	58 dB
Integrated sensors	Accelerometer, Infrared sensor
Number of programs	14
Dust capacity (total)	0.48 L
HEPA filtration system	-
Floor surfaces supported	Carpet, Hard floor
Threshold climbing (max)	20 mm
Battery life	250 m²
Battery capacity	5200 mAh
Power consumption (typical)	58 W

Weight and Dimensions

Depth	350 mm
Width	353 mm
Height	96.5 mm