023
Routine Maintenance
To maintain optimum performance, maintain the robot according to the following guidelines:
Part
Maintenance
Frequency
Omni-Directional
Wheel
Use a screwdriver or similar tool to pry out the axles.
Rinse, allow to dry and press the wheel back in place.
As required /
Charging Contacts (Robot) Wipe clean with a soft dry cloth.Monthly /
Cli Sensors Wipe clean with a soft dry cloth.Monthly /
Main Brush
Rotate the fasteners of the main brush caps in the
unlocking direction and take them down. After removing
the debris wrapped around the brush, reinstall the main
brush caps in the locking direction.
2 weeks 6-12 months
Charging Contacts
(Charging Dock)
Wipe clean with a soft dry cloth.Monthly /
Carpet Sensor Wipe clean with a soft dry cloth.Monthly /
Washable Filter 2 weeks 6-12 months
Remove and rinse, gently tapping to remove any dirt.
Air-dry for at least 24h before reuse.
Use a screwdriver to unscrew the side brush. Remove any
entangled dirt and screw it back in place.
Side Brush Monthly 3-6 months
Remove and clean the mop cloth after each use.VibraRise Mop Cloth After each use 3-6 months
Dock Locator Wipe clean with a soft dry cloth.Monthly /
Main Wheels Wipe clean with a soft dry cloth.Monthly /
Replacement
Frequency
Maintenance Method
Note: Replacement frequency will vary depending on the actual situation. Should abnormal wear and tear occur, replace the relevant part.
To Next Page
Loading...
Need help?
General
