16
Basic Parameters
Model S82USV
Battery
14.4V/5200mAh (TYP)
lithium-ion battery
Rated Input 20V
1.5A
Charging Time Approx. 4 hours
Robot
The serial number is on a sticker on the underside
of the robot.
Note:
Empty Wash Fill Dock
Model EWFD13LRR
Rated Input Voltage 120V~
Rated Frequency 60Hz
Rated Input
(Dust collection)
6A
Rated Input
(Hot water mop
washing)
12A
Rated Input
(Charging & drying)
1.35A
Rated Output 20V
1.5A
Charging Battery
14.4V/5200mAh (TYP)
lithium-ion battery
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution. Remove
the battery before disposing of this product
and hand it to a professional battery
recycling facility for centralized disposal.
1. Operate the robot without connecting to
the dock until it runs out of battery.
2. Turn off the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the latch to pull out the battery
connector and remove the battery.
*
The following information applies only when
disposing of the robot and should not be followed for
day-to-day operations.
Removing the Battery
Environment
Protection Information
Notes:
Ŏ
Before removing the battery, make sure it is fully
drained. Do not attempt to remove the battery if the
robot is connected to the dock.
Ŏ
Remove the entire battery pack. Avoid damaging the
battery pack casing to avoid short-circuits or leakage
of hazardous substances.
Ŏ
In the event of accidental contact with battery fluid,
rinse thoroughly with water and seek immediate
medical care.