The Sleep-Mode
How to Operate the Controller
Anti-lost feature
BIKI might fall outside the sonar range when moving in the water, thus
lost contact. To lower the losing probability, the anti-lost feature is
developed. BIKI will automatically stop moving and will head above
the surface to wait for further order if there’s no operational command
comes from the remote control within 15secs.
CAUTION:
1.Please deactivate Sleep-Mode before use.
2.When use the remote control, please make sure
it in the same media with BIKI.
10
The controller uses the mechanical switch. When
not in use for 5mins, it will go into sleep mode (red
light flicks once). Long press “ ”till blue light
flickers twice to activate the controller.
While in the water, the remote control gives out sound wave signal
by the built-in acoustic transducer. BIKI moves according to the
signals it received from the remote control. Communication
medium: water; communication means: sound wave; ultrasound
wave: 27kHz, within the civil-used frequency band.
How to use the remote control
To Next Page
Loading...