Robustel GoRugged R2000 Quick Guide
RT_QG_R2000 _v.1.0.0 07.09.2015 5/16
2.3 Ground the Router
Grounding and wire router helps limit the effects of noise due to electromagnetic interference (EMI). Run the ground
connection from the ground by screwing to the grounding surface before connecting devices.
Note: This product is intended to be mounted to a well-grounded mounting surface, such as a metal panel.
2.4 Mount the Router
The router may be placed on a horizontal surface such as a desktop, mounted on a DIN-rail, or mounted on the wall.
Two ways of mounting the router
1. Use 4 pcs of M2.5 screw to fix the router on the two metal plates.
And then use 2 pcs of M3 screw with point-end to mount the router with two metal plates on the wall.
Recommended torque for mounting is 0.5N.m and the maximum torque is 0.7N.m.
2. Mount the router on a DIN rail with 3 pcs of M3 screws, and then hang the DIN-Rail on the holder.
You need to choose a standard holder. Recommended torque for mounting is 1.0N.m and the maximum torque
is 1.2N.m.
Note: When mounting the unit on a DIN-rail, make sure that it is oriented with the metal springs on top.
2.5 Connect R2000 to PC with Ethernet cable
Use a standard cross-over Ethernet cable to connect R2000 to PC with Eth0 or Eth1 port.
To Next Page
Loading...
