To Next PageTo Next Page
Need help?Do you have a question about the Roca AVO-512F-AG and is the answer not in the manual?
Inspect equipment upon reception, dispose of packing responsibly, note refrigerant type.
Ensure qualified installation, follow safety standards, and heed cautions.
Install outdoors on a stable base, maintaining adequate clearances for airflow.
Ensure leakproof circuits, insulate tubing, and evacuate system to remove air/humidity.
Install drain with slope, ensure no leaks, and insulate to prevent condensation.
Use PVC pipe with slope, check flow and absence of leaks after installation.
Select location, drill holes, and route cable for wall remote control unit.
Check voltage, use appropriate cable section, and ensure qualified wiring with safety system.
Connect cables to terminals 'L', 'N', and grounding screws for single and three-phase supplies.
Connect signal cables to the indoor unit board and fasten securely.
Check power, obstructions, temperature settings, and refrigerant for unit issues.
Clean filters daily, check intakes/outlets seasonally, and ensure proper grounding.
General