2. The app will automatically turn back to the WiFi network list and
nd out the SSID Name labeled on the bottom of the mesh node,
input the given default password and connect to the network.
3. After the mesh node will nally connect to the network, open
the RS WiFi app again. If the page showing up is the scaning one,
click the name of the network on the upper left side of the page
and return to the rst page of the app. You do not need to scan for
a second time.
4.
Follow the given instructions. The setup wizard appears. Tap "Setup".
5. The app automatically detects your internet connection type.
Enter information according to the internet connection type and
tap "Next". The mesh unit is connected to the Internet and the app
proceeds to the next step.If your Internet connection type is PPPoE.
Enter your PPPoE user name and password and tap "Next”.
If your internet connection type is dynamic IP, tap "Next".
If your internet connection type is static IP, enter your IP address and
other information your ISP provides, and tap "Next".
6. When the mesh unit and the app is connected successfully,
it says" Connected".
7. The instruction will guide you to the Wireless Setting page for
further customizing your personal WiFi Name and Password of the
mesh. Tap "OK" when you nish setting up the new one.
Note: If you change the wireless network nameand password and
tap "OK", your mobile phone will disconnect with the mesh Wi-Fi
network. You need to reconnect to the new wireless network you
congured.
8. When the indicator of the mesh unit turns solid green,
it is connected to the Internet.
To Next Page
Loading...
Need help?
General
