WPS
PWR
WPS
Signal
Method 1:Via a Web Browser
1. Connect your computer or smart phone to the extender’s
network "rockspace_EXT " . When you are using a computer,
unplug the ethernet cable if any. When you are using a
smart phone, ensure the mobile data is disabled.
Power On
1. Plug in the extender about halfway between your router
and the Wi-Fi dead zone. The location you choose must be
within the range of your router.
2. Wait for about 2 minutes until the Signal LED turns blue.
If it doesn't, relocate the extender closer to the router to
achieve better signal quality.
3. Select the Wi-Fi network you want to extend.
4. Enter the password of the Wi-Fi network you want to extend.
WLAN
rockspace_EXT
2. The login window pops up automatically. If it doesn't, launch a web
browser and enter 192.168.0.254 or www.rockspacewifi.com
manually to get started. Create your admin password and record
it down for later use.
*Note: If the login window does not appear, refer to FAQ > Q1.
Admin password
Conrm admin password
Next Not Now
www.rockspacewifi.com
Your existing Wi
WiFi password
-Fi network
The password is the same as your exsiting
WiFi network
The extended WiFi network
Extended SSID
Cancel Completed
Wait until the page shows you “Wireless network extended successfully"!
Note: By default, the extended network uses the same wireless network name (SSID)
as your router. Change the extended SSID if you need.
Suitable location, at a halfway
point between your router
and the dead zone.
Too close to the router,
extended Wi-Fi signal can
not cover the dead zone.
Too far away from the router,
the extender will lose
connection with your router.
Method 2: Via the WPS Button
1. Press the WPS button on the router.
2. Within 2 minutes, press the WPS button on the extender.
3. Wait until the Signal LED on the extender turns blue,
indicating successful connection. If the Signal LED does not
turn blue, try again or use Method 1.
WPS
PWR
WPS
Signal
Press
1
Relocate the
Wi-Fi Range Extender
3
2
Set Up
Reset PinholeEthernet Port
WPS Button
Meet Your Extender
Red
Blue
Signal LED
WPS LED
Blinking
Power LED
On
This LED indicates the connection
between the extender and the router.
Best connection.
Poor connection.
No connection.
WPS connection is in progress.
O
Wi-Fi security is not enabled.
The extender is powered on.
The extender is powered o.
Quick Installation Guide
AC2100 Dual Band Wi-Fi Range Extender
Model No. RSD0623
Plug the extender into a power outlet next to your router.
Wait until its Power LED turns blue.
Hot-line: +1 (833) 816-6558
Email: techsupport@rockspace.cc
Service Time: EST 10:00-21:00 from Monday to Friday
Need FREE technical support?
Scan the QR code or visit
https://rockspaceworld.com
24/7 Online After-sales Service
Method 1: Via a Web Browser
1. Connect your computer or smartphone to the extender’s
network "rockspace_EXT ". When you are using a computer,
unplug the Ethernet cable if any. When you are using a
mobile phone, ensure the mobile data is disabled.
WPS LED
Power LED
Signal LED
Please select a Wi-Fi network you
want to extend
Connect
WPS
PWR
WPS
Signal
WPS
PWR
WPS
Signal
WPS
PWR
WPS
Signal
To Next Page
Need help?
General
