15
5. Put on the cover on top of the water reservoir.
6. Plug in the machine.
7. Turn the on/off switch (A-4) to the on position “1” and open the steam handle (A-1). Boiler water fill starts (you
will hear the pump’s noise).
8. When the boiler is properly filled with water, the pump will stop (=no more noise). Now close the steam
handle (A-1).
9. The heating up of the boiler water starts.
10. Wait till the boiler pressure gauge (A-3) reads approximately 1 bar.
11. Now open the steam handle (A-1) for 5 seconds to let out some steam. This operation is very important as
it removes possible vacuum inside the boiler which will reflect in suction of milk inside the boiler itself once
starting to steam milk. Close the steam handle (A-1) again.
12. Wait until the boiler pressure gauge (A-3) reaches again 1 Bar.
13. Pull the lever (A-9) completely up.
14. Allow a cup of water to come out of the coffee brewing group (A-6).
15. Pull the lever (A-9) completely down (water will stop flowing).
Now the machine is ready for operation.
To Next Page
Loading...
Need help?
General
